Kukagua transceiver

Timu yetu inashughulikia tafsiri. Makala hii haipatikani kwa Kiswahili kwa sasa, kwa hiyo inaonyeshwa kwa Kiingereza.

The Check transceiver screen is the starting point of the online application. It reads the module identity and diagnostics and presents them in a readable form.

What it reads

When a module is inserted (or the simulator provides one), the app reads its memory and shows:

Identity — vendor, part number, serial number and form factor.
Capabilities — supported rates, wavelength, reach and connector type.
Digital diagnostics (DDM) — live temperature, supply voltage, laser bias and optical TX/RX power. See DDM basics.

Reading a module

Insert the transceiver into the programmer (or connect the simulator).
Open Check transceiver.
Review the identity block at the top and the DDM values below.
To edit memory, continue to the Editor.

Status colours

Colour	Meaning
Green	Value within the module's normal range
Amber	Warning threshold crossed
Red	Alarm threshold crossed

Diagnostic values update live while the module is connected. In simulator mode the values are representative sample data.

Ukipata kasoro au kosa katika makala hii, chagua sehemu husika kisha ubonyeze Ctrl+Enter ili .